Installation Guide

Carefully push wiring and wire connectors
into outlet box. Leave hook end of motor
assembly in square opening of hanging
bracket and lift the other end of motor
assembly toward hanging bracket.
Align motor assembly screw holes with
hanging bracket screw holes and re-insert
motor mounting screws that were
previously removed (Section 5, page 4).
Securely tighten all motor mounting
screws with a Phillips screwdriver.
8. Motor Housing Assembly.
page 5
7. Fan Assembly.
Hold motor housing up to hanging bracket to
determine which 2 screws align with slotted holes
on top rim of motor housing. Lower motor
housing and partially loosen the 2 screws in
hanging bracket that correspond to slotted holes
in motor housing. Remove the other two screws
from hanging bracket.
Raise motor housing to hanging bracket again,
allowing slotted holes in motor housing to align
with loosened screws in hanging bracket. Twist
motor housing to lock. Re-install the 2 screws that
were removed and then tighten all screws to
secure motor housing.
motor
mounting
screws
motor
mounting
screw
motor
housing
screws
motor
housing
screws
motor
housing