Installation Guide

DOWNROD-STYLE FAN MOUNTING

Depending on the length of downrod you use,

you may need to cut the lead wires back to

simplify the wiring. If you decide to cut back the

lead wires, it is suggested you do so in the

following manner:

Take the lead wires and make sure you have

pulled them all the way through the top of the

downrod. Start at the TOP of the hanging ball on

the downrod and measure 8 in. of lead wire, and

then cut the excess wire off with wire cutters (not

included).

NOTE: If you do not cut back the lead wires,

Steps 4 and 5 are not necessary and you may

proceed to Step 6 instead.

Hanging

Ball

8 in.

If you decided to cut back the lead wires in Step 4,

strip 1/2 in. of insulation from end of each

wire -- white, black, green and blue (if applicable).

Twist stripped ends of each strand of wire within

the insulation with pliers (not included).

Install hanging ball of downrod (A) into opening of

mounting bracket (C). Align one of the slots in

hanging ball with tab in mounting bracket (C).

DANGER: Failure to align one of the slots in

the ball with the tab may result in serious injury or

death.

Hanging

Ball Slot

Tab