MSDS

Wall Texture Bag MSDS v2 Page - 2 - of 4 3/10/08
#2012
SECTION 5 - FIRE FIGHTING MEASURES
FLASH POINT: N/A METHOD USED: CC (Closed Cup)
FLAMMABLE LIMITS IN AIR BY VOLUME: LOWER: N/A UPPER: N/A
EXTINGUISHING MEDIA: This product is inert and unlikely to burn. In case of fire, use water, dry
chemical or foam.
SPECIAL FIREFIGHTING PROCEDURES: N/A
UNUSUAL FIRE & EXPLOSION HAZARDS: N/A
SECTION 6 - ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: When dry: sweep
and dispose of in proper receptacle. When wet: Scoop into proper receptacle and allow to harden. Always
adhere to the guidelines for regulations set forth by local, state/province and federal authorities for waste
disposal.
SECTION 7 - HANDLING & STORAGE
PRECAUTIONS TO BE TAKEN IN HANDLING & STORAGE: Store material in a cool, dry
location. Do not take internally. Keep out of reach of children.
OTHER PRECAUTIONS: This material is a commercial product designed to be used by professionals
familiar with the requirements of this MSDS.
SECTION 8 - EXPOSURE CONTROLS/PERSONAL PROTECTION
PRECAUTIONS TO BE TAKEN IN USE:
Adequate ventilation required if used in confined area.
Avoid breathing vapor or spray mist.
Avoid contact with skin and eyes.
Wash hands after handling.
RESPIRATORY PROTECTION: RECOMMENDED. Wear a proper dust respirator approved by
NIOSH/MSHA for protection against materials listed in Section 2. If material is ground upon or sanded
when it is dry, NOISHA/MSHA approved respirators for dust should be worn. All workers required to
wear respirators should be trained in their proper selection, use and care.
SKIN PROTECTION: RECOMMENDED. Wear protective gloves that are impermeable such as
neoprene or resistant gloves such as butyl rubber and are recommended by the glove supplier to protect
against chemical listed in Section 2.
EYE PROTECTION: RECOMMENDED. Wear protective goggles or a face shield in compliance with
OSHA.