Installation Manual

WARNING:
READ CAREFULLY BEFORE INSTALLING
RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Sensor must be wired in accordance with the National Electrical Code and all applicable local codes.
Risk of fire or electric shock. Sensor installation requires knowledge of luminaire electrical systems. If not qualified,
do not attempt installation. Contact a qualified electrician.
Be certain electrical power is OFF before and during installation and maintenance.
Make sure the supply voltage is same as the rated Sensor voltage
Only those open holes indicated in the photographs and/or drawings may be made or altered as a result of this kit
installation. Do not leave any other open holes in an enclosure of wiring or electrical components.
Review the sensor settings section and complete any necessary DIP switch setting changes.
Mount the sensor so the lens is below the edge of the fixture and away from the lamps. Heat from the lamps could affect
the sensor operation. Make sure that you have the appropriate accessories for the sensor mounting configuration.
Assemble any necessary mounting accessories and attach them to the sensor module. Make sure that the flying leads
from the sensor module cable are accessible inside the fixture.
Connect the line voltage and load wires to the sensor leads as shown in the applicable wiring diagram for the
sensor module.
Do not allow exposed bare wires.
Make sure all connections are secure.
SAFETY INSTRUCTIONS AND WARNINGS
Sensor (MC031V)
Split-Grommet
Bracket