Installation Manual

6
6. Punch hole through side knockout of strip xture or drill a hole
through the center of the cover (that was set aside in step 3) near
the incoming electrical wires with 20mm bi-metal hole saw (sold
separately ordering code RFAHS-20).
8. Insert the power cord and split snap
bushing into knockout hole or newly
drilled hole. Reconnect the male and fe
-
male halves of the Luminaire disconnect.
7. Push the included power cord through the split snap
bushing.
9. Replace the xture (ballast) cover.
5. Connect incoming electrical line to the included female
disconnect by pushing the wires into the corresponding color
coded black and white holes.
RF16UQT1XXC, RF32UQT1XXC, RF45UQT1XXC
4’ & 8’ STRIP FIXTURE INSTALL