Installation Manual

24
RF32UHT1XX, RF45UHT1XX, RF32UQT1XXC AND RF45UQT1XXC
INTERCONNECTING STANDALONE USE
1c. Restore the power and you’re done! Enjoy your new energy
saving LED RetroFit
1b. Place the Retrot accessory (RCAC, RFAC-8IN or RFAC-4FT)
to connect both the Retrot’s together.
1a. Place and align the second 1’ x 4’ LED RetroFit RF32UQT1XXC
or RF45UQT1XXC with the C14 socket or Litetronics logo as
close to the rst LED Retrot as needed to allow use of RetroFit
accessory (RFAC, RFAC-8IN or RFAC-4FT) by repeating the wire
cable accessory steps 11-18 in this section.
For interconnecting install. Do not restore power before you complete steps 1a-1c below.
Our 1x4’s can be assembled into long chains o one power source depending on Retrot wattage. Connect 2
retrots when aligned together using the dual connector (RFAC).You can also connect 2 retrots together when
less than or equal to 4’ apart using 4ft lamp to lamp extension (RFAC-4FT). Or connect 2 retrots together when
less than or equal to 8” apart using 8in lamp to lamp extension (RFAC-8IN). Shown on page 4.
Maximum Length by Watts
32W = 18 Units
45W = 12 Units