Manualshelf

Installation Manual

ManualsBrandsLitetronics ManualsOtherLitetronics End-to-End Connector for 1'x4' LED Troffer Retrofit
11121314151617181920
16
6. Unscrew and remove ballast from xture.
8. Connect the male disconnect to the female disconnect that is
attached to the included power cord.
7. Connect the incoming electrical wires to the included female
disconnect.
If you are installing LED retrot into a wrap xture, instead of removing the lamp holders, just cut the remaining
ballast wires as close to the lamp holders as possible.
5. Remove lamp holders and mounting bracket.
RF32UQT1XXC AND RF45UQT1XXC
TROFFER OR WRAP INSTALL
4. Disconnect ballast wires from the incoming
electrical line. (black and white wires)