Installation Manual

14
1b. Place the dual connector (RFAC) into the sockets to connect both
the LED RetroFits together.
1e. Restore the power and you’re done!
1c. Align the second xture and secure with 2 included self-tapping
screws
1d. Apply both included labels to the xture.
1a. Place and align the second 1’ x 4’ LED RetroFit RF32UQT1XXC or
RF45UQT1XXC with the C14 socket (or Litetronics logo) as close to the rst LED
Retrot as needed to allow use of RetroFit accessory.
For 8’ install. Do not restore power until you complete steps 1a-1e below.
RF32UHT1XX, RF45UHT1XX, RF32UQT1XXC AND RF45UQT1XXC
HARDWIRE STRIP FIXTURE INSTALL
Any unused branch power circuits supplying interconnected retrot luminaires should be properly terminated.
Our 1x4’s can be assembled into long chains o one power source depending on Retrot wattage. You can
connect 2 retrots together when less than or equal to 4’ apart using 4ft lamp to lamp extension (RFAC-4FT). Or
connect 2 retrots together when less than or equal to 8” apart using 8in lamp to lamp extension (RFAC-8IN).
Shown on page 4.
Maximum Length by Watts
16W = 36 Units
32W = 18 Units
45W = 12 Units