Installation Manual

12
11. Connect conduit wires to LED RetroFit using wire nuts
(included). See below chart:
a. black to black
b. white to white
c. green to green/yellow
13. The other end of the conduit will go into the xture.
Remove the conduit nut. Push the three wires into the xture
hole, then through the conduit nut, and secure . Connect
conduit wires to incoming electrical lines inside xture.
Connect black to black, white to white with wire nuts. Then
connect the green/yellow with strip of ground screw.
12. Replace the end cover, and secure it with the two screws.
10. Insert the three conduit wires (black, white & green)
through the hole of end cover. Then place the conduit nuts
over the three conduit wires. After that, push conduit end into
knockout hole and secure with conduit nut.
RF32UHT1XX, RF45UHT1XX, RF32UQT1XXC AND RF45UQT1XXC
HARDWIRE STRIP FIXTURE INSTALL