Installation Manual

10
1. Turn o power to the xture from the circuit breaker.
3. Open xture cover to expose the ballast and set the cover
aside.
1. Retrot must be installed to a grounded luminaire.
2. Hardwire install does not use a junction box.
3. Ballast cover should be mechanically secured to physically support the Retrot.
2. Remove existing uorescent tubes. Recycle according to
EPA guidelines (EPA.Gov).
4. Disconnect ballast wires from the incoming electrical
lines. (Black and white wires).
RF32UHT1XX, RF45UHT1XX, RF32UQT1XXC AND RF45UQT1XXC
HARDWIRE STRIP FIXTURE INSTALL
1x4 Hardwire Strip Fixture with T8 Tubes 1x4 Hardwire Strip Fixture with LED Retrot
Before After
Section 2