Motion & Light Sensor Kit HBAS47 Installation Instructions For Round High Bay Fixtures PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLATION Motion Sensor_Installation Instructions_v1.
SAFETY INSTRUCTIONS AND WARNINGS WARNING: READ CAREFULLY BEFORE INSTALLING RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE. Sensor must be wired in accordance with the National Electrical Code and all applicable local codes. Risk of fire or electric shock. Sensor installation requires knowledge of luminaire electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician. Be certain electrical power is OFF before and during installation and maintenance.
12 13 TOOLS TYPICALLY USED FOR INSTALLATIONS Wire Stripper (optional) Wire Cutter (optional) Phillips Screwdriver Drill WHAT COMES IN THE BOX Motion Sensor base product comes with following standard parts: Adjustable Hinge Bracket Sensor Motion and Light Sensor Kit HBAS47 PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLATION (2) Self-tapping screws (1) Installation Instructions Before Installation, carefully remove all parts from the packaging. Inspect product for defects due to shipping.
MOTION SENSOR INSTALLATION 1. Turn off power to fixture. Look for 2 holes on curved surface of housing where bracket of sensor will be installed. 2. Install bracket with help of 2 selftapping screws. 3. Remove pre-connected input cable with 3 stripped wires by twisting connector counter clockwise. 4. Mate waterproof twist male connector of High Bay driver with female connector of sensor by twisting clockwise to lock. 4 Motion Sensor_Installation Instructions_v1.
MOTION SENSOR INSTALLATION 5. Mate male connector of sensor and pre-connected input cable (removed in step 3) or any chosen Litetronics cable accessory by twisting clockwise. 6. Connect 0-10V gray and purple wire of High Bay and sensor with help of wire nuts (waterproof) provided with High Bay. 7. To set sensor functionality, remove screw from plastic cover and then unscrew top cover from sensor assembly. You will see dip switch. See MC031V settings on next page (6). Replace sensor cover and screw. 8.
MOTION SENSOR INSTALLATION MC031V SENSOR SETTINGS By selecting the combination on the DIP switch, sensor data can be precisely set for each specific application.
MOTION SENSOR INSTALLATION TROUBLESHOOTING REASON CAUSE REMEDY The load will not illuminate Incorrect daylight sensor setting selected. Adjust setting. Load had failed. Replace load. Power is switched off. Switch on. The load is permanently illuminated. Continuous movement in the detection area. Check detection area setting. The lamp (Containing sensor) is installed in an area too close to reflective surfaces, i.e. metal, glass or concrete walls.
Thank you for choosing 6969 W. 73rd Street Bedford Park, IL 60638 WWW.LITETRONICS.COM CustomerService@Litetronics.com or 1-800-860-3392 v1 (2-15-18) Motion Sensor_Installation Instructions_v1.
