User's Manual

User Manual Rev 1.11
Basic/Smart/Smart Plus/Intelligent Charger-32A
56
Cellular APN – This is the gateway for all cellular traffic. Contact your cellular operator for information
about this. For AT&T and Verizon LTE service, just leave it blank since the apn name is built-in in the
modem.
APN Username – This is the user name your ISP has assigned to you (optional).
APN Password – Password to log into the ISP network (optional).
Dial Number – Phone number to dial for cellular network.
PIN Code – PIN code for the modem’s SIM card (optional). 4 digit number.
Primary DNS – The primary Domain Name Server (optional).
Secondary DNS – The secondary Domain Name Server (optional).
Cellular Signal Strength – The strength of cellular signal in dBm.
Local Load Management (LLM) Settings [Support only on SC3+/IC3]
Local load management is the process of balancing the supply of electricity on the network with the
electrical load by adjusting or controlling the load of each charge point in a local group which is based on
Gateway/Client architecture. The Gateway IC3 must be manually set to the maximum current limitations
so that it will dynamically adjust output current in each Client SC3+/IC3 by charging policy.
When LLM function is on, all charge points will request for charging to Gateway, and Gateway will
calculate the proper current limit and reply to each Client. Each charge point will only allow charging
when received a current limit from Gateway. If disconnection occurred between a Client and Gateway
then the Client will use fallback value as the limitation.
Local Load Management – Enable or disable Local Load Management function. This function can only be
enabled in a Gateway or Client charge point.