User's Manual

User Manual Rev 1.11
Basic/Smart/Smart Plus/Intelligent Charger-32A
43
Voltage Low – Value at which the charge point will send an under voltage warning message.
Voltage High – Value at which the charge point will send an over voltage warning message.
General Settings
Output Power Type – AC or DC output power. In our product, this value is always “AC”.
Power Phase Connected – Input power phase connected to the charge point to indicate single phase or
three phases. This value is always “1”.
Max Amperage HW Setting – The DIP switches (Hardware) settings to indicate the maximum charging
current.
Max Amperage FW Setting – The software settings to indicate the maximum charging current.
PWM Amperage – The PWM setting for charging current when the charge point is online. This signal is
to tell EV how much current is allowed to use.
Real Amperage – The real-time charging current detected by the charge point.
Cold Load Pickup Max Delay – Default cold load pickup delay is 120s ~ 720s. The max value could be
changeable by this property.