User's Manual

User Manual Rev 1.11
Basic/Smart/Smart Plus/Intelligent Charger-32A
26
Input cord connection (for SC3+/IC3 only)
1. Choose the appropriate conduit in accordance with all applicable state, local and
national electrical codes and standards.
Figure 3-13 Conduit. Figure 3-14 Right angle conduit
2. Clamp copper terminal to connect copper wire. The clamp point is covered by heat shrink
tube for protecting.
2-1 Refer to the following wire specification. Use conductor type other than RHH, RHW and RHW-2
with outer covering.
Model
Terminal
Conductor
Rating
Smart Charger Plus-32A
Intelligent Charger-32A
L1, L2,G
8 AWG
90C copper wire
Figure 3-15 Copper terminal, heat shrink tube and copper wire.