Datasheet
13
0.2
3.0
8.2
2.6
SOLDER MASK
UNITS: mm
Adjacent Land Keep-Out and
Solder Mask Areas
Adjacent land keep-out is the
maximum space occupied by the unit
relative to the land pattern. There
should be no other SMD components
within this area.
The minimum solder resist strip width
required to avoid solder bridging
adjacent pads is 0.2 mm.
It is recommended that two fiducial
crosses be place at mid-length of the
pads for unit alignment.
Note: Wet/Liquid Photo-Imageable
solder resist/mask is recommended.