User's Manual

1 Introduction

This document describes how to start RF test mode or AP mode, under test firmware.

1.1 Test Bench Setup

1) DUT software version: WP8721_TestFW_Rv0.0.3_20170524

2) COM port configuration:

Bits per second / Data bits / Parity / Stop bits / Flow control: 38400/8/None/1/None

3) Power adapter: 802.3at/af PoE or 12V DC

4) DUT default IP address: 192.168.1.254 in AP mode; 192.168.1.6 in RF test

mode

5) Configure PC NIC IP address as 192.168.1.0 subnet, for example:

192.168.1.100.



DUT

Switch

Console

COM

GE1

DC Powe