Getting Started Guide

3. Place the rst mounting post on the rear-side of
the device on to the lower notch of the bracket.
4. Rotate the device such that all the mounting
posts on the rear-side of the device are snapped
in to the respective notches on the bracket.
Getting the WP8333V5 Online
Step 1: Pow
er up
If using PoE, plug one end of the Ethernet cable into the PoE switch or injector and plug the other end
into the Ethernet + PoE port (LAN1) on the C-110. Make sure the PoE source you are using is turned ON.
OR
As an alternative to PoE, insert the power adapter plug into an AC power outlet and the other end into
the power input port on the unit.
Warning: If powering the device with PoE, ensure that the device is connected to a UL listed indoor PoE
source. If not using PoE, ensure that you use only an AC power adapter supported by accessing point
(AP).
Step 2: Connect to the network
If you are using PoE, then the unit should already be connected to your network. If you are not using
PoE, then plug one end of the Ethernet cable into an Ethernet jack on your network and the other end
into the Ethernet port (LAN1) on the unit.