WP8333V5 Getting Started Guide Package Contents You should have received the following components in your WP8333V5 package. Mounting the WP8333V5 1. Affix bracket to T - Grid. 2. Rotate bracket to snap on to T- Grid.
3. Place the first mounting post on the rear-side of the device on to the lower notch of the bracket. 4. Rotate the device such that all the mounting posts on the rear-side of the device are snapped in to the respective notches on the bracket. Getting the WP8333V5 Online Step 1: Power up If using PoE, plug one end of the Ethernet cable into the PoE switch or injector and plug the other end into the Ethernet + PoE port (LAN1) on the C-110. Make sure the PoE source you are using is turned ON.
Step 3: Check the LED status Wait for a few minutes till the LEDs for Power and Ethernet (LAN1) turn solid GREEN, which indicates that the unit is online and operational. Troubleshooting LED Status Description Power Solid Green Power On Off Power Off Solid Green Device connected to LAN port 1 at 10/100/1000 Mbps Blinking Green Activity on LAN port 1 Solid Green Device connected to LAN port 2 at 10/100/1000 Mbps Blinking Green Activity on LAN port 2 Solid Green No activity on 2.
For FCC Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
For IC This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is sub. ject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired opera tion of the device.
For JP 5GHz band (W52, W53): Indoor use only (except communicate to high power radio)
