User Manual
Page 7 of 8
3 Mechanical and Environment Design
3.1 Case (details refer to ME drawing separately)
A. ID/Tool (leverage WP8336-AB)
This ID is a small form factor within 146x146mm. The bottom ID/ME shall seamlessly
(without tooling updates) support potential different styles of top cover for customers.
The ID has a Kensington lock hole on the enclosure.
B. I/O port (back view, ordering from right to left)
DCIN RESET LAN1 LAN2
(PoE)
C. Mounting Kit
1. It needs to accommodate Mojo four mounting kits for T-bar and hard surface mount.
2. There are three T-bar width supported, 15, 24 and 38mm.
3. The hard flat surface mounting including wall and ceiling mount
a. standard, 2 key holes in the central part on bottom case (optional)
b. optional accessory, separate bracket
3.2 Physical & Environment
3.2.1 Power
- PoE DC 48V
- Optional external power adapter, (to be quoted separately)
Input: 100-240VAC, 50/60Hz
Output: Switching12V DC/1.5A (for DC jack center pin 2.0mm)
- Reset Button: Reset to factory default by pushing button for 5 sec