User's Manual

14
 WPA configuration
Enable WPA Authenticator to require stations to use
high grade encryption and authentication.

WPA Enable.

PSK: Enter a text pass phrase up to 63 characters.

WPA Multicast Cipher Type: Currently TKIP is the
only permitted setting.
 WPA Pairwise Cipher Type: Currently TKIP is the only
permitted setting.
 WPA Group Key Update Interval.
 WEP configuration
WEP is the wireless encryption standard. To use it
you must enter the same key(s) into the bridge and the
access point. For 64 bit keys you must enter 10 hex
digits into each key box. For 128 bit keys you must enter
26 hex digits into each key box. A hex digit is either a
number from 0 to 9 or a letter from A to F. If you leave
a key box blank then this means a key of all zeros.

Enable WEP : Check this box to enable WEP. For the
most secure use of WEP, also select “Deny Unencrypted
Data” and set Authentication to “Shared Key” when
WEP is enabled.
 WEP key lengths: Select the WEP key size. This
length applies to all keys.
 Default WEP key to use: Select the key to be used
as the default key. Data transmissions are always en-
crypted using the default key. The other keys can only
be used to decrypt received data.

WEP key.