User's Manual

IMPORTANT NOTE:
This module is intended for OEM integrator. The OEM integrator is responsible for the compliance
to all the rules that apply to the product into which this certified RF module is integrated.
Additional testing and certification may be necessary when multiple modules are used.
USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep at least 20 cm
separation with the antenna while this end product is installed and operated. The end user has to
be infored that the FCC readio-frequency exposure guidelines for an uncontrolled environment
can be satisfied. The end user has to also be informed that any c
hanges or modifications not
expressly approved by the manufacturer could void the user's authority to operated this equipment.
If the size of the end product is smaller than 8x10cm, then additional FCC Part15.19 statement
is required to be availabe in the users manual: (1) this device may not cause harmful interference
and (2) this device must accept any interference received, including inteference that may cause
undesired operation.
OEM/Integrators Installation Manual
The OEM integrator has to be aware not to provide information to the end user regarding how
to install or remove this RF module in the user manual of the end product. The user manual of the
end product which is provided by OEM integrators for end users must include the following
information in a prominent location.
1. To comply with FCC RF exposure compliance requirements, the antenna used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons
and must not be co- located or operating in conjunction with any other antenna or transmitter,
except in accordance with FCC multi transmitter product transmitter product procedures.
It is the responsibility of the professional installer to ensure that the system.
2. Only those antennas with same type and lesser gain filed under this FCC ID number can be
used with this device.
3. The regulatory label on the final system must include the statement: “Contains FCC ID:
PPQ-WN4639R“.