User's Manual

WN4636R Page 4/8 2014/8/26

Warning: Changes or modifications to this unit not expressly approved by

the party responsible for compliance could void the user authority to operate

the equipment.

1. This Transmitter must not be co-located or operating in conjunction with

any other antenna or transmitter.

2. For product available in the USA market, only channel 1~11 can be

operated. Selection of other channels is not possible.

IMPORTANT NOTE:

This module is intended for OEM integrator. The OEM integrator is still responsible

for the FCC compliance requirement of the end product, which integrates this module.

Appropriate measurements (e.g. 15 B compliance) and if applicable additional equipment

authorizations (e.g. Verification , Doc) of the host device to be addressed by the

integrator/manufacturer.

20cm minimum distance has to be able to be maintained between the antenna and the users

for the host this module is integrated into. Under such configuration, the FCC radiation

exposure limits set forth for an population/uncontrolled environment can be satisfied.

Any changes or modifications not expressly approved by the manufacturer

could void the user's authority to operate this equipment.

Antenna General Information

No.

Ant. Cat.

Ant. Type

Model name

Gain

(dBi)

Integral

PIFA

WN4636R

0.16

Integral

PIFA

WN4636R

0.82

Note: The EUT Supported CCD Funection

USERS MANUAL OF THE END PRODUCT:

In the user manual of the end product, the end user has to be informed to keep at least 20cm

separation with the antenna while this end product is installed and operated. The end user has

to be informed that the FCC radio-frequency exposure guidelines for an uncontrolled

environment can be satisfied. The end user has to also be informed that any changes or

modifications not expressly approved by the manufacturer could void the user's authority to