User's Manual

Ben J. Chen Page 7 10/8/2012
SOFTWARE INSTALLATION
Install the device
1. Make sure the computer is turned off. Remove the expansion slot cover from the
computer.
2. Carefully slide the 802.11b/g/n 2T2R USB WLAN Module into the USB slot. Push
evenly and slowly and ensure it is properly seated.
3. After the device has been connected to your computer, turn on your computer.
Windows will detect the new hardware and then automatically copy all of the files
needed for networking.
WiFi module uses 2 metal antennas on sensor board as its antennas to
transmit and receive data.