User's Manual
WN4520L Page 11/15 2017/7/26
End Product Labeling
Thefinalendproductmustbelabeledinavisibleareawiththefollowing:"ContainsFCCID:
PPQ‐WN4520L”
IMPORTANT NOTE:
This module is intended for OEM integrator.
The OEM integrator is still responsible for
1. ensuring that the end-user has no manual instructions to remove or install module
2. the FCC compliance requirement of the end product, which integrates this
module.
3. Appropriate measurements (e.g. 15 B compliance) and if applicable additional
equipment authorizations (e.g. Verification, Doc) of the host device to be
addressed by the integrator/manufacturer.
4. The separate approval is required for all other operating configurations, including
portable configurations with respect to Part 2.1093 and different antenna
configurations
USERS MANUAL OF THE END PRODUCT:
The module is limited to installation in mobile or fixed applications
In the users manual of the end product, the end user has to be informed to keep at
least 20cm separation with the antenna while this end product is installed and
operated. The end user has to be informed that the FCC radio-frequency exposure
guidelines for an uncontrolled environment can be satisfied. The end user has to
also be informed that any changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate this equipment. If the size of
the end product is smaller than the palm of the hand, then additional FCC part 15.19
statement is required to be available in the users manual: This device complies with
Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.