User Manual

Page 5/13
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be
installed such that 20cm may be maintained between the antenna and users. The final
end product must be labeled in a visible area with the following: "Contains FCC ID:
PPQ-WN4508R ”
Information for the OEMs and Integrators
The following statement must be included with all versions of this document supplied
to an
OEM or integrator, but should not be distributed to the end user.
1) This device is intended for OEM integrators only.
2) Please see the full Grant of Equipment document for other restrictions.
This device is operation in 5.15 – 5.25GHz frequency range, then restricted in indoor
use only, Outdoor operations in the 5150~5250MHz is prohibit.
This device is slave equipment, the device is not radar detection and not ad-hoc
operation in the DFS band.
PRODUCT FEATURES
 Operate at ISM frequency Band (2.4 / 5GHz)
 IEEE Standards Support, 802.11a , 802.11b, 802.11g and 802.11n
 Support USB 2.0 host interface
 Enterprise level security supporting: WPA, WPA2, TKIP, AES, WAPI
 Two-stream IEEE 802.11n support for 20MHz and 40MHz bandwidth channels
provides PHY layer rates up to 300Mbps
 RoHS compliance
 Low Halogen compliance