User's Manual

This device is operation in 5.15 – 5.25GHz frequency range, then restricted in indoor use
only.
This device is slave equipment, the device is not radar detection and not ad-hoc operation
in the DFS band.
FCC NOTICE: To comply with FCC part 15 rules in the United States, the system must
be professionally installed to ensure compliance with the Part 15 certification. It is the
responsibility of the operator and professional installer to ensure that only certified
systems are deployed in the United States. The use of the system in any other
combination (such as co-located antennas transmitting the same information) is
expressly forbidden.
Only the antennas listed below are allowed to be used with the EUT output power.
Antenna List
No.
Manufacturer
Part No.
Peak Gain
NOTE
1
AmTRAN
EDB-18S with metal reflector
2.5 dBi in 2.4GHz
4.5 dBi in 5.0GHz
with metal reflector
(Output power #1)
2
AmTRAN
EDB-45S with metal reflector
2.5 dBi in 2.4GHz
4.5 dBi in 5.0GHz
3
AmTRAN
MSA-3025-25GC4 with metal reflector
4.21 dBi in 2.4GHz
4.5 dBi in 5.0GHz
4
AmTRAN
FPA-3025-25GC4 with metal reflector
4.26 dBi in 2.4GHz
6 dBi in 5.0GHz
5
AmTRAN
EDB-18S
2 dBi in 2.4GHz
3 dBi in 5.0GHz
without metal reflector
(Output power #2)
6
AmTRAN
EDB-45S
2 dBi in 2.4GHz
3 dBi in 5.0GHz
7
AmTRAN
MSA-3025-25GC4
2.54 dBi in 2.4GHz
4 dBi in 5.0GHz
8
AmTRAN
FPA-3025-25GC4
2.75 dBi in 2.4GHz
4.5 dBi in 5.0GHz
NOTE:
1. There are two different EUT output power for with ground plane antenna and without ground plane
antenna.
2. About Output power, please refer to report: 113119R-RFUSP32V01、113119R-RFUSP32V01-A、
113119R-RFUSP42V01、113119R-RFUSP42V01-A