User manual 802.11n, Dual Band 2T2R Wireless USB Module WN4501L Version 1.1 Author: Ben J. Chen Editor: Ben J. Chen Project Leader: Jason Chien Approved by: Jason Chien Change History Revision Version 1.0 Date 2012/03/29 Author Ben J. Chen Version 1.1 2012/06/05 Ben J.
CONTENT PRODUCT FEATURES .................................................................................................................... 4 WI-FI FEATURE ...................................................................................................................................... 4 PRODUCT SPECIFICATIONS ........................................................................................................ 5 MAIN CHIPSET ..........................................................................
PRODUCT FEATURES Wi-Fi Feature Operate at ISM frequency Band (2.4GHz/5GHz) IEEE Standards Support, 802.11a, 802.11b, 802.11g and 802.11n The WN4501L is developed using single-chip designed by Realtek Semiconductor Corp. Complies with USB Specification 2.
PRODUCT SPECIFICATIONS MAIN CHIPSET Realtek RTL8192DU FUNCTIONAL SPECIFICATIONS Wi-Fi Function Standard IEEE802.11a; IEEE802.11b; IEEE 802.11g; IEEE 802.11n Bus Interface USB Interface Data Rate 802.11b: 11, 5.5, 2, 1 Mbps 802.11a/g: 54, 48, 36, 24, 18, 12, 9, 6 Mbps 802.11n: MCS 0 to 15 for HT20MHz MCS 0 to 15 for HT40MHz Media Access Control CSMA/CA with ACK 802.11b: CCK, DQPSK, DBPSK 802.11a/g: Modulation Techniques 64QAM, 16QAM, QPSK, BPSK 802.
Receiver Sensitivity Security 13 dBm@MCS0 13 dBm@MCS7 13 dBm@MCS15 802.11n(5GHz): 20MHz: 15 dBm@MCS0 11 dBm@MCS7 11 dBm@MCS15 40MHz: 15 dBm@MCS0 11 dBm@MCS7 11 dBm@MCS15 802.11a: -76 dBm@54Mbps 802.11b: -86 dBm@11Mbps 802.11g: -77 dBm@54Mbps 802.11n(2.4GHz): 20MHz -74 dBm@MCS7 -71 dBm@MCS15 40MHz -70 dBm@MCS7 -67 dBm@MCS15 802.11n(5GHz): 20MHz -72 dBm@MCS7 -69 dBm@MCS15 40MHz -69 dBm@MCS7 -66 dBm@MCS15 WEP 64&128bit, WPA, WPA2, WPS, IEEE 802.1X, IEEE 802.11i Operating Voltage 3.
PIN ASSIGNMENT Pin.
EEPROM INFORMATION Reg Domain World Wide 2.
PACKING DRAWING Page 11/11
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digi tal device, pursuant to part 15 of the FCC rules.
1. To comply with IC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co- located or operating in conjunction with any other antenna or transmitter, except in accordance with IC multitransmitter product transmitter product procedures. 2. Only those antennas with same type and lesser gain filed under this IC ID number c an be used with this device. 3.
