User's Manual

WN4300R Specification Page 8/8 2007/2/1
LTC Network Access Confidential
The final end product must be labeled in a visible area with the following " Contains TX FCC
ID: PPQWN4300R ". If the size of the end product is larger than the palm of the hand, then
the following FCC part 15.19 statement has to also be available on the label: This device
complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Industry Canada Notice to Users
Operation is subject to the following two conditions:
(1)this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 3dBi. Antennas not included in this list or having a gain greater than 3dBi
are strictly prohibited for use with this device. The required antenna impedance is 50ohms.
Antenna
Ant. Brand Antenna Type Connector Gain (dBi)
1 Wistron PIFA (INTERNAL) UFL 3.00
2 Wistron Dipole (W/O cable)-XCC Reversed-SMA 2.00
3 Wistron Dipole (With 1m cable)-XCD Reversed-SMA 2.00
4 Joymax Dipole (With 1m cable) Reversed-SMA 1.95
Internal cable for Dipole Antenna
1 26cm-1.37Ø
2 26cm-1.13Ø
3 9.5cm-1.37Ø
4 9.5cm-1.13Ø