User Manual

ManualsBrandsLITE-ON Technology ManualsElectronics802.11a/b/g mini-PCI WLAN card

Wireless LAN 802.11a/b/g Device

Introduction

Your Stargate TV module functions as a Wireless Local Area

Network (WLAN) connecting with other wireless product(s)

via 802.11 technology.

802.11 technology allows over-the-air connection between

devices. Your Stargate TV module is equipped with an

802.11a/b/g product which allows fast (up to 54Mbps)

connection rates

Installing the Wireless LAN

802.11a/b/g Device Antenna

The Wireless LAN 802.11a/b/g Device is embedded in the

Stargate TV module and needs the antenna supplied with

your Stargate TV module to be connected. Once connected,

your Stargate TV module is ready to begin functioning in

station mode (as a client) with your Wireless Local Area

Network.

Note:

It is assumed that there is an existing wireless LAN

network with an Internet connection (please consult your

ISP for further information).

Package contents consist of an antenna with a

connector located at the end (A) that screws into the

antenna jack located on the back of the Stargate TV module

(B).

A) Antenna Installation

1. Screw the antenna connector (A) to the antenna jack (B)

located on the back of the Stargate TV module.

2. Place the Stargate TV module on a table or place the

antenna in an elevated and open area to achieve the best

wireless performance

B) Troubleshooting

Prior to contacting customer support check the following

items and reboot the Stargate TV module:

1. Verify that both the Stargate TV module as well as the

wireless broadband router/access point are powered.

2. Verify that the antenna is connected securely to the back

of your Stargate TV module.

English

Summary of content (4 pages)

PAGE 1
Introduction A) Your Stargate TV module functions as a Wireless Local Area Network (WLAN) connecting with other wireless product(s) via 802.11 technology. 802.11 technology allows over-the-air connection between devices. Your Stargate TV module is equipped with an 802.11a/b/g product which allows fast (up to 54Mbps) connection rates. 1. 2. Antenna Installation Screw the antenna connector (A) to the antenna jack (B) located on the back of the Stargate TV module.
PAGE 2
C) Customer Support Customer support information can be obtained from System Warranty and Support Guide. INFORMATION TO USER Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 3
-Increase the separation between the equipment and IMPORTANT NOTE: receiver. FCC Radiation Exposure Statement: -Connect the equipment into an outlet on a circuit different This equipment complies with FCC radiation exposure limits from that to which the receiver is connected. set forth for an uncontrolled environment. This equipment -Consult the dealer or an experienced radio/TV technician for should be installed and operated with minimum distance help. 20cm between the radiator & your body.
PAGE 4
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization. If this module will be operated in 5.15 ~ 5.