User Manual

Kaysa Lee Page 3 2/1/2013
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user authority to operate
the equipment.
1. This Transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
2. For product available in the USA market, only channel 1~11 can be
operated. Selection of other channels is not possible.
IMPORTANT NOTE:
This module is intended for OEM integrator. The OEM integrator is still responsible
for the FCC compliance requirement of the end product, which integrates this module.
20cm minimum distance has to be able to be maintained between the antenna and the
users for the host this module is integrated into. Under such configuration, the FCC
radiation exposure limits set forth for an population/uncontrolled environment can be
satisfied. End-users and installers must be provide with antenna installation instructions
and transmitter operating conditions for satisfying RF exposure compliance.
Any changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate this equipment.
The operation frequency of the device is in the 5150-5250 MHz band is for indoor use
only. A warning message should be provided in the user’s manual.
FCC Label Instructions:
The outside of final products that contains this module device must display a label
referring to the enclosed module. This exterior label can use wording such as the
following: “Contains Transmitter Module FCC ID: PPQ-WCBN603MH” or “Contains
FCC ID: PPQ-WCBN603MH” Any similar wording that expresses the same meaning
may be used.