User's Manual

WB116A Page 9/10 2015/10/15

This module is intended for OEM integrator. The OEM integrator is still responsible for the

IC compliance requirement of the end product, which integrates this module.

Any changes or modifications not expressly approved by the manufacturer could void the

user's authority to operate this equipment.

USERS MANUAL OF THE END PRODUCT:

In the users manual of the end product, the end user has to be informed to keep at least 20cm

separation with the antenna while this end product is installed and operated. The end user has

to be informed that the IC radio-frequency exposure guidelines for an uncontrolled

environment can be satisfied. The end user has to also be informed that any changes or

modifications not expressly approved by the manufacturer could void the user's authority to

operate this equipment. Operation is subject to the following two conditions: (1) this device

may not cause harmful interference and (2) this device must accept any interference received,

including interference that may cause undesired operation.

LABEL OF THE END PRODUCT:

The final end product must be labeled in a visible area with the following " Contains TX IC :

4491A-WB116A ".

Antenna list:

Ant.

Brand

Holder

Model Name Antenna Type Connector Gain (dBi)

SONY

Corporation

WB116A Printed Antenna

N/A 0.24

Note: The EUT has one antenna.