Bluetooth Module WB110C (WB110C-IW) User’s Manual
Federal Communication Commission Interference Statement 7KLV HTXLSPHQW KDV EHHQ WHVWHG DQG IRXQG WR FRPSO\ ZLWK WKH OLPLWV IRU D &ODVV % GLJLWDO GHYLFH SXUVXDQW WR 3DUW RI WKH )&& 5XOHV 7KHVH OLPLWV DUH GHVLJQHG WR SURYLGH UHDVRQDEOH SURWHFWLRQ DJDLQVW KDUPIXO LQWHUIHUHQFH LQ D UHVLGHQWLDO LQVWDOODWLRQ 7KLV HTXLSPHQW JHQHUDWHV XVHV DQG FDQ UDGLDWH UDGLR IUHTXHQF\ HQHUJ\ DQG LI QRW LQVWDOOHG DQG XVHG LQ DFFRUGDQFH ZLWK WKH LQVWUXFWLRQV PD\ FDXVH KDUPIXO LQWHU
USERS MANUAL OF THE END PRODUCT: The end user has to be informed that the FCC radio-frequency exposure guidelines for an uncontrolled environment can be satisfied. The end user has to also be informed that any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment. If the size of the end product is smaller than 8x10cm, then additional FCC part 15.
1 INTRODUCTION 1.1 WB110C (-IW) Bluetooth Module WB110C (-IW) Bluetooth Module uses CSR BC4 ROM A07 chip which fully qualified Bluetooth v2.1+EDR system. The features of Bluetooth V2.1 is improved pairing, improved security, lower power consumption, and near field communication technology. With Enhanced Data Rate (EDR mode), the rate up to 2Mbps and 3Mbps. This module controls in USB interface and is compliance with USB v1.1 and compatible with USB v2.0.
1.2 How to works The module refers to a worldwide Bluetooth SIG standard. Before transfer data to each other, two BT modules must establish a connection. One device requests the connection with another and the second one accept it. Then user can use different data transfer function wirelessly between two Bluetooth devices.
1.3 Product Features Bluetooth® V2.1+EDR system (backwards compatible with v1.1/1.2 /2.0devices) Class II (Max +4 dBm, 2.5mW) ʳ 4Mbits integral ROM Enhanced Data Rate (EDR) compliant for both 2Mbps and 3Mbps modulation modes Integrated Printed Antenna Tiny Form Factor Support OS: Windows based OS Full-speed Bluetooth operation with full Piconet support Scatternet support Extended SCO (eSCO) support 1.8V core, 1.7 to 3.6V I/O Low-power 1.8V operation (integral 1.
1.4 System Requirements System should meet the following items: -MB supports matched USB connector -Windows XP/Vista -60MB free disk for installing the Toshiba stack 1.
