Installation Guide

Wireless Enrollment
Flashing Blue | WPS Mode
To enter WPS mode, push the WPS button and release
when flashing blue (about 3 seconds).
See instructions
above to add the camera to your router and account
using WPS.
Flashing White | AP Mode
To enter AP mode, push the WPS button and release
when flashing white (about 6 seconds).
See instructions
above to add the camera to your router and account
using AP mode.
Factory Reset
Flashing Green & Red | Factory Reset
WARNING: This will restore factory-default settings to
the camera. If already installed, the camera may need
to be removed from the Alarm.com account and re-
added after a factory reset.
To perform a factory reset,
push the WPS button and release when flashing Green
and Red (about 15 seconds).
8 ADC-V523 Installation Guide