Installation Guide

AP Mode
Add the Camera to an Alarm.com Account
To ensure sufficient Wi-Fi signal, complete these
steps with the camera near its final location but prior
to mounting.
1 Connect the camera’s AC power adapter and plug it
into a non-switched outlet.
2 Hold down the WPS button and release when the LED
begins to flash white (about 6 seconds).
3 On an Internet enabled device, connect to the wireless
network “ALARM (XX:XX:XX)” where XX:XX:XX is
the last six digits of the ADC-V523’s MAC address,
which is located on the back of the ADC-V523.
4 On the same device, open a web browser and enter
“h t tp: / /522ir inst all” in the U RL field. F ollo w the o n-
screen instructions to add the ADC-V523 to the
wireless network. The LED will be solid green when the
connection is complete.
ADC-V523 Installation Guide 3