User's Manual

MZ0100S-1 Product Specification Page 7/9
LTC Network Access Confidential
FCC WARING STATEMENT
This equipment has been tested and found to comply with the limit s for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment of f and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the p arty responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20 centimeters between
the radiator and your body.
Information to OEM integrator
The OEM integrator has to be aware not to provide information to the end user regarding how to install or re
move this RF module in the user manual of the end product. The user manual which is provided by OEM inte
grators for end users must include the following information in a prominent location.
1. To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be i
nstalled to provide a separation distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other
antenna or transmitter, except in accordance with FCC multi‐transmitter product
transmitter product procedures.