Data Sheet

LILY-W1 series - Data sheet
UBX-15000203 - R12 Antennas Page 31 of 42
C1-Public
Name U.FL to Reverse Polarity SMA adapter cable
Connector U.FL and Reverse Polarity SMA jack (outer thread and pin)
Impedance 50
Minimum cable loss
0.5 dB, The cable loss must be above the minimum cable loss
to meet the regulatory requirements
. Minimum cable length
100 mm.
Comment The Reverse Polarity SMA connector can be mounted in a
panel. This reference design must be followed to
comply with
the LILY-W1 FCC/IC modular approvals. For information
about how to integrate the U.FL connector, see also the LILY
-
W1 series system integration manual [2]
Approval FCC, IC, MIC, NCC and RED
8.2 Approved antennas
8.2.1 Single band antennas
Ex-It 2400 28 RP-SMA
Manufacturer ProAnt
Polarization Vertical
Gain +3.0 dBi
Impedance 50
Size Ø 12.0 x 28.0 mm
Type Monopole
Connector Reverse Polarity SMA plug (inner thread and pin receptacle).
Comment To be mounted on the U.FL to Reverse Polarity SMA adapter cable. This
antenna needs to be mounted on a metal ground plane for best
performance. An SMA version antenna is also available but not
recommended for use (Ex-It 2400 28 SMA).
Approval FCC, IC, MIC, NCC and RED
Original part number at certification: Ex-IT 2400 RP-SMA 28-001
ANT-2.4-CW-RH-RPS
Manufacturer Linx
Polarization Vertical
Gain -1.0 dBi
Impedance 50
Size Ø 7.4 x 27.0 mm
Type Monopole
Connector Reverse Polarity SMA plug (inner thread and pin receptacle).
Comment To be mounted with a U.FL to Reverse Polarity SMA adapter cable.
An SMA
version antenna is also available but not recommended for use
(ANT-2.4-CW-RH-SMA).
Approval FCC, IC, MIC, NCC and RED