Data Sheet

LILY-W1 series - Data sheet
UBX-15000203 - R12 Qualification and approvals Page 28 of 42
C1-Public
Only the antennas approved by the MIC and shown in Approved antennas are allowed for use with
this MIC certificate.
The end product holder shall also include a copy of the Japan Radio Certificate to the end product
technical documentation. Contact your local support team for a copy of the Radio certificate.
7.4 Taiwan compliance
Approval is pending for LILY-W133.
The LILY-W131 and LILY-W132 modules are certified to be used on the Taiwan market.
7.4.1 Warning statement
Statement translation:
Without permission granted by the NCC, any company, enterprise, or user is not allowed to change
frequency, enhance transmitting power or alter original characteristic as well as performance to
an approved low power radio-frequency devices.
The low power radio-frequency devices shall not influence aircraft security and interfere legal
communications; If found, the user shall cease operating immediately until no interference is
achieved. The said legal communications means radio communications is operated in compliance
with the Telecommunications Act. The low power radio-frequency devices must be susceptible
with the interference from legal communications or ISM radio wave radiated devices.
7.4.2 LILY-W131 labeling requirements for end product
When a product integrated with a LILY-W131 module is placed on the Taiwan market, the product
must be affixed with a label marking as shown below. The label can use wording such as the following:
Contains Transmitter Module
:
:
CCAI16LP1250T6
or any similar wording that expresses the same meaning may be used. The marking must be visible
for inspection.
7.4.3 LILY-W132 labeling requirements for end product
When a product integrated with a LILY-W132 module is placed on the Taiwan market, the product
must be affixed with a label marking as shown below. The label can use wording such as the following:
Contains Transmitter Module
:
:
CCAI16LP1280T2
Any similar wording that expresses the same meaning may also be used. The marking must be visible
for inspection.