Data Sheet

LILY-W1 series - Data sheet
UBX-15000203 - R12 Qualification and approvals Page 27 of 42
C1-Public
In accordance with 47 CFR § 15.19, the end product shall bear the following statement in a
conspicuous location on the device:
"This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation."
When the device is so small or for such use that it is not practicable to place the statement above on
it, the information shall be placed in a prominent location in the instruction manual or pamphlet
supplied to the user or, alternatively, shall be placed on the container in which the device is marketed.
In case, where the final product will be installed in locations where the end-user is not able to see the
FCC ID and/or this statement, the FCC ID and the statement shall also be included in the end-product
manual.
7.2.5 FCC and IC IDs
Model FCC ID IC ID
LILY-W131 XPYLILYW1 8595A-LILYW1
LILY-W132 XPYLILYW1 8595A-LILYW1
LILY-W133 XPYLILYW1 8595A-LILYW1
Table 18: FCC and IC IDs for different models of the LILY-W1 series
7.3 Japan radio equipment compliance
The LILY-W1 module complies with the Japanese Technical Regulation Conformity Certification of
Specified Radio Equipment (ordinance of MPT N°. 37, 1981), Article 2, Paragraph 1:
Item 19 "2.4 GHz band wide band low power data communication system"
The LILY-W1 MIC certification number is 204-610007.
The very small size of the module makes it impactable to fit the GITEKI mark and certification
number onto the module label. Instead, the Giteki mark and certification number must be affixed
to the end product.
When a product integrated with a LILY-W1 module is placed on the Japanese market, it must have a
label affixed on an exterior surface. The label must contain all the information presented in Figure 6.
The English translation of the Japanese text displayed below the Giteki mark
contains specified radio equipment that has been certified to the Technical Regulation Conformity
Certification under the Radio Law.
The marking must be visible for inspection.
204- 610007
Figure 6: Giteki mark,
R
and the LILY-W1 MIC certification number
The recommended size of the Giteki mark is Ø5.0 mm but the minimum size is Ø3.0 mm.