Data Sheet

LILY-W1 series - Data sheet
UBX-15000203 - R12 Qualification and approvals Page 26 of 42
C1-Public
7.2.3 FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that the
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
The LILY-W1 module is for OEM integrations only. The end-user product will be professionally
installed in such a manner that only the authorized antennas are used.
For LILY-W131 represents an external antenna connector (U.FL. connector) reference design. Note
that the LILY-W1 series system integration manual [2]) must be strictly followed to comply with the
LILY-W1 FCC/IC modular approval.
Any changes or modifications NOT explicitly APPROVED by u-blox could invalidate compliance with
FCC rules part 15 and void the user's authority to operate the equipment.
7.2.3.1 Cautions
Any changes or modifications could cause the module to cease to comply with
FCC rules part 15 and thus void the user's authority to operate the equipment.
§15.407 statement; in case of absence of information to transmit or operational failure, the
LILY-W1 module will automatically discontinue transmission.
7.2.4 Labeling requirements for end product
For an end product using the LILY-W1 modules there must be a label containing, at least, the following
information:
This device contains
FCC ID: XPYLILYW1
IC: 8595A-LILYW1
The label must be affixed on an exterior surface of the end product such that it will be visible upon
inspection in compliance with the modular approval guidelines developed by the FCC.