User's Manual

Charge on.

3 Installation

3.1 Before Installation

3.1.1 Safety Check

CAUTION: DISCONNECT ELECTRICAL POWER PRIOR TO INSTALLING or REPAIR THE BLINK

CHARGER. FAILURE TO DO SO MAY CAUSE PHYSICAL INJURY OR DAMAGE TO THE ELECTRICAL

SYSTEM AND BLINK CHARGING UNIT.

The Blink Charger should be installed only by a licensed contractor, and/or a licensed electrician in accor-

dance with all applicable state, local and national electrical codes and standards.

Before installing the Blink Charger, review this manual carefully and consult with a licensed contractor, li-

censed electrician and trained installation expert to ensure compliance with local building practices, climate

conditions, safety standards, and state and local codes.

Use appropriate protection when connecting to the main power distribution cable. Use tools as outlined in the

section “Tools Required for Installation”.

3.1.2 Grounding Instructions

This product must be connected to a grounded, metal, permanent wiring system; or an equipment grounding

conductor must be run with the circuit conductors and connected to the equipment grounding terminal or lead

on the product.

3.2 Tools & Parts Required for Installation

Table 3-1. Tools & Parts Required for Installation.

Tool Size Supplier

EVSE Mounting Bracket N/A Model Accessories

Torx Bolts (4each) - used to secure the

EVSE to the mounting bracket

T20 (On the Model) Model Accessories

Terminal tube Color: Red, Black, Green Model Accessories

Terminal Model Accessories

Conduit – used for power wire 1” Commercially available

Bolts (4 each) – used to secure the

main body mounting braket on the

wall

M8x18 lag bolts with lock wash-

ers

Commercially available

Torx Driver T20 Commercially available

Slotted Screwdriver Commercially available

Philips Screwdriver PH3 Commercially available

Bolts (for masonry) M8, expansion Commercially available

Torque Wrench Commercially available

Wire, Copper No. 8 AWG, 75°C or 90°C Commercially available