User's Manual

Canada — Low-power license-exempt radio communication devices (RSS-210)
a. Common information Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
b. Operation in 2.4 GHz band To prevent radio interference to the licensed service,
this device is intended to be operated indoors and installation outdoors is subject to
licensing.
Canada - de faible puissance exempts de licence des appareils de communication
radio (CNR-210)
a. Informations communes
Son fonctionnement est soumis aux deux conditions suivantes:
1. Ce dispositif ne peut causer des interférences, et
2. Ce dispositif doit accepter toute interférence, y compris les interférences qui
peuvent causer un mauvais fonctionnement du dispositif.
b. Le fonctionnement en bande de 2,4 GHz Pour prévenir les interférences
radioélectriques aux services sous licence, cet appareil est destiné à être exploité à
l'intérieur et à l'extérieur d'installation est soumise à licence.
Information To Be Supplied to the End User by the OEM or Integrator
Modular information form OEM
Information to Be Supplied to the End User by the OEM or Integrator
The following regulatory and safety notices must be published in documentation supplied to
the end user of the product or system incorporating an adapter in compliance with local
regulations.
Host system must be labeled with "Contains IC: 4491A-IMP002 “
This device is to be used only for mobile and fixed application. In order to re-use the imp Module
IC approvals the antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter. If antenna is installed with a separation distance of less than
20 cm from all persons or is co-located or operating in conjunction with any other antenna or transmitter
then additional IC testing may be required. End-Users must be provided with transmitter operation
conditions for satisfying RF exposure compliance.
OEM integrators must ensure that the end user has no manual instructions to remove or install
the imp module. The EUT has two antenna types (External & PIFA antenna) that as below.
Antennas used for this OEM module must not exceed 2dBi gain for External Antenna, and 2.86dBi is
for PIFA one. Both are for mobile and fixed operating configurations.
IC Warning