User's Manual

Setting Nevo
SL
Up
10 Nevo
SL
Quick Start Guide
• Battery
The options you set will apply when Nevo
SL
is undocked and relying on
its rechargeable battery. To conserve battery power and increase the
length of time between charges, set these for as short as possible.
• AC Power
The options you set will apply when Nevo
SL
is docked in the recharging
station, using the electrical power from your outlet.
• Switch state to User Idle
Set the time that should pass between when you last use Nevo
SL
and when
it turns its screen off. You can reactivate the screen simply by touching the
screen or any hard button.
• Switch state to System Idle
Set the time that should pass between when you last use Nevo
SL
and when
it turns its hard drive off. You can reactivate Nevo
SL
simply by touching the
screen or any hard button.
• Switch status to Suspend
Set the time that should pass between when you last use Nevo
SL
and when
it turns off completely. You must press the ON button to reactivate Nevo
SL
.
Device Status
This screen contains technical details that will help Customer Support
troubleshoot any problems you might have. There are no settings on this
screen that you can change.
Calibrating the Screen
If you find that the Nevo
SL
touchscreen is not responding properly to your
commands, you may need to calibrate the screen. To do so:
1. Touch Screen Calibration.
2. Read the directions on screen, then touch the center of the + displayed.
Follow the screen instructions.
need an image of the scrren
calibration settings; those buttons do
not appear to be active on my
emulator software.
NevoQuickStart.book Page 10 Monday, January 10, 2005 11:07 AM