User's Manual

2.2 Power Switch
Power on:
Slide the switch to the on position (marked “1”). The power LED will come on.
Power off:
Slide the switch to the off position (marked “0”). The power LED will switch off.
2.3 Power Jack
The power jack lets you to connect either a car charger (included) or AC charger
(optional) to power the BTG-100/110 and recharge the internal battery.
2.4 LED Indications
Battery Status LED (Green/Orange/Red):
Red Blinking
Orange
Green
Battery power is critically low. Charge immediately.
Battery is charging.
Battery is charged
Bluetooth Status LED (Blue):
Blinking once every 3 seconds
Blinking once every 5 seconds
Pairing/discovery mode
Connected to other Bluetooth device.
GPS Status LED (Yellow):
Fast blinking
Slow blinking
Steady light
Searching
2D GPS position is fixed
3D GPS position is fixed
2.5 How to insert the battery
1. Open the battery compartment door
2. Put new battery into BTG-100/110
3. Close the battery compartment door
NOTE: Please initially charge the battery for 3 hours.
2.6 Power-saving Function
If the BTG-100/110 is not connected to any devices for 5 minutes, it will switch off
automatically, and all LEDs will also switch off simultaneously.
External antenna connector