User's Manual

1. Kit Contents
2. Installation
IMPORTANT SAFETY CAUTION
IF IT IS NECESSARY DISARM OR REMOVE AN SRS AIRBAG, MANUFACTURER’S
PROCEDURE MUST BE FOLLOWED. FAILURE TO DO SO MAY RESULT IN AIRBAG
DEPLOYMENT AND POSSIBLE INJURY OR DAMAGE TO VEHICLE.
INSTALLATION PROCEDURE
NOTES—The switch must be fitted to the right side of the steering wheel as the buttons are not
reversible.
The battery supplied in the hardware is a spare to be given to the owner of the vehicle. The
switch already contains a long life battery.
Mount the “Cruise Engage“ LED (small white LED with black-sheathed 3 wire harness) in a
location on the dashboard where it can be seen by the driver.
Mount the oval “CRUISE “ decal and secure the LED with small black plastic retaining grommet.
Mount the interface module in an appropriate location (i.e. behind dashboard) and connect the
LED with 3 wire harness. CAUTION! Do not connect to a powered harness. Ensure all
connections are complete before supplying power or testing operation.
Plug cruise engage LED harness (red, yellow and green wires in white plug) into 3 pin white
socket right side on the interface module.
Switch harness (6 wires in short harness, flat white plug and 2 row clear plug). Connect flat white
plug into 6 pin white socket on the interface module, and clear 2 row plug into switch socket on
main cruise control wiring harness.
SWITCH INSTALLATION IS NOW COMPLETE