hd Safety Instructions Use for the Intended Purpose Use other than as intended can lead to injury to the driver or third parties, or to damage to property or the environment. For this reason, the product must be used only according to the intended purpose! GENIUS 300 PLUS is a radio remote control unit for electrical or pneumatic central locking systems.
Installation Selecting the Installation Site install the control electronics of the GENIUS 300 PLUS in the interior of the vehicle under the dashboard. Install the power-on lamp (LED) at a visible place in the dashboard. Ensure that the antenna is not tied fo live cables, The an-senna must neither be shortened nor extended! ATTENTION Electrical Connection Risk of short circuits due to faulty connections.
GENIUS 300 PLUS WIRING DIAGRAM LED ANTENNA FLASHER? FLASHER] DOOR LOCK.
Connection to central locking control by interruption of neg. Conn.
Connection to central locking with dual-pressure pump grid wordily bil hs rdfyl Dual-pressure pump + Switch for driver's door or passenger Ger's door of trunk (boot) lid 4. 30 ert mmm Disconnect original lead Vehicle-Specific Settings How to use ‘Code Learning’ a) Turn the ignition on and off twice and then turn the ignition back on within a 7 second period. b)LED fast flashes for 3 seconds.
Resetting the PIN Number (For Internal Use only) The procedure for returning the PIN code to default is as follows Remove the top case Disconnect the power from the module Turn the ignition on (12 volts on orange wire) Link jumper (JP) on pcb Turn on the power (12 volts on RED wire} Siren will chirp twice to confirm that the PIN has been reset. Remove the jumper The PIN will then be reset to default.
Software Features Software Software Switch Function Default on off Switch Setting | Setting 1 ) Passive ARM/DISARM Mode OFF ON OFF 2 Passive Arming with Lock OFF ON OFF 3 Anti-Hijack {ON/OFF} OFF ON OFF 4 Ignition On door Lock ON ON OFF [] Motor/ Vacuum Locking 0.58 0.58 48 7 Auto Re-arm ON ON OFF 8 Auto Re-lock ON ON OFF g Dome Light Cars OFF ON OFF 10 Herr Siren Hom Horn Siren fn PIN Override Code 1 Setting between 1 {Press both buttons once to entry change. if both and 9.
Function: 1. Disarming When the alarm is armed and the doors locked the LED will flash slowly to indicate that the system is armed, The system will sound for 30 seconds when triggered. : When the alarm system is disarmed, the siren will chirp twice (when the setting of software switch “10° is siren), the indicators will flash twice, the LED will tum off and the central door locking will unlock. 2. Panic Holding button 1 for more than 3 seconds will activate panic mode.
6. Intrusion Warning If the alarm has triggered during an armed period, the siren will beep 4 times {when the setting of software switch “10” is siren) when the system is disarmed to indicate to the driver that the alarm has been triggered. : 7. Passive Arming Turning off the ignition and then opening and closing a door will cause the indicators to flash twice and LED to flash quickly to indicate that the passive arming sequence has begun.
. Zone By Pass When the alarm system is triggered by a door or ignition three times in one armed period the alarm system will then ignore any further signals from that sensor. All other s sensors and the starter kill will remain activated when the sensor is by passed. 11. PIN Code Disarming If the alarm system is armed and the user has broken their transmitter or the batteries are exhausted, then the disarm code can be used to enable the user to start the vehicle.
iv) After this 30 second alarm sounding period, the internal immobilizer will energies to immobilize the vehicle and the siren and flashers will keep flashing. This period will last for 60 seconds. v} After this period, the system will return to the arm mode with the doors unlocked, but the indicators will continue to flash until the alarm is completely disarmed by the Disarm Code.
