Installation Guide

STI/WRX LIT LOGOSSTI/WRX LIT LOGOS
INSTALLATION GUIDE
| 6839 CORALBERRY LN N, JACKSONVILLE, FL 32244 | P: 434-209-7166 | WWW.LIT-LOGOS.COM
INCLUDED PARTS
1 -
1 -
4 -
1 -
Lit Logos Control Box
Lit Logos STI/WRX logo
Zip Ties
Lit Logos decal
HOW TO INSTALL
1. Disconnect the car battery
2. Remove the bumper to gain access to the backside of
the grill
3. Line up the logo on the front of the grill where you
would like to install it. Run the wire through one of the
holes in the grill.
If you have a ne mesh grill, you may need to snip one or
two of
the mesh links to allow the wiring to t through.
4. Place two zip ties in the holes located on the left and
right side of the logo, one in each hole. DDo not securo not securee
them yetthem yet.
5. Remove the backing from the 3M and adhere the logo
to the grill. Keep constant pressure on it for at least 60
seconds.
6. Secure the logo to the grill with supplied zip ties.
These are used as a secondary securing method along
with the 3M. Do not overDo not overtightentighten as the zip tie holes can
break if the zip ties are torqued down.
7. Find where you want to connect the logo to power.
Any 12V power source will work but a 5A fuse is required to
be used to protect the logo from a power surge no matter
where the logo is powered from.
8. Route the power and ground wire from the
control box to the location you chose to power
the logo, avoiding any high heat or moving parts.
9. Tuck the Control Box out of the way, but still within
reach of the front bumper where you installed the logo.
Be sure to place this somewhere that wont be hit by
road debris, direct water, or high heat. This is the brains
of the Lit Logo. It is water and heat resistant, but high
pressure water or extreme temperatures can damage the
electronics.
10. Connect the Lit Logo to the Contol Box using the
waterproof quick disconnect. Ensure that the arrowsEnsure that the arrows
line up on the connectorline up on the connector and the red gasket is in place. and the red gasket is in place.
Thread the locking nut into place all the way to ensure aThread the locking nut into place all the way to ensure a
waterproof connection.waterproof connection.
11. Reinstall the bumper and re-connect the battery.
CONTINUED BELOW...