Installation Guide
GR86 LIT LOGOSGR86 LIT LOGOS
INSTALLATION GUIDE
| 6839 CORALBERRY LN N, JACKSONVILLE, FL 32244 | P: 434-209-7166 | WWW.LIT-LOGOS.COM
TROUBLESHOOTING STEPS
We hope you never have any issues with your logo,
but if you do, here are the best steps to take to get it
working again as quickly as possible:
• Turn o Bluetooth on your phone, uninstall and rein-
stall the app, and try to connect to the logo again
• Ensure the ground source is clean and connected
directly to unpainted metal. We recommend connect-
ing the ground wire to the same location the battery
is grounded to
• Try a dierent power source. Sometimes a fuse tap
wont reach far enough into the fuse or the wire wont
provide enough power, so try connecting the logo
directly to the battery with an inline fuse
• Check the app and ensure the logo is set to “GRB
SK6812_RGBW” and the pixels should be set to 30
• Make sure the logo is switched to the “on” position
in the app
• Make sure that the bottom slider on the app control is
turned all the way down
• Make sure that the top slider on the app control is
turned all the way up
• Try using a dierent phone to connect to the logo
• Check that the arrows on the quick disconnect
between the logo and the control box are pointing
towards each other
• Disconnect the logo from power and leave o for 12
hours
LED HUE BLUETOOTH APP
Download the LEDHue app from the App Store/Google
Play store. Below are some tips for using the LEDHue app
to control your Lit Logo:
11. Reinstall the bumper and re-connect the battery.
10. Connect the Lit Logo LED Housing to the Contol Box
using the waterproof quick disconnect. Ensure that theEnsure that the
arrows line up on the connectorarrows line up on the connector and the red gasket is in and the red gasket is in
place.place. Thread the locking nut into place all the way toThread the locking nut into place all the way to
ensure a waterproof connection.ensure a waterproof connection.
You may need to remove, or at least trim some of the
plastic crash material from the crash bar to ensure the
bumper can go back into place without pushing on the
LED Housing.