SDS

Provide general supportive measures and treat symptomatically. Keep victim warm. Keep victim
under observation. Symptoms may be delayed.
Indication of immediate
medical attention and special
treatment needed
IF exposed or concerned: Get medical advice/attention. If you feel unwell, seek medical advice
(show the label where possible). Ensure that medical personnel are aware of the material(s)
involved, and take precautions to protect themselves. Show this safety data sheet to the doctor in
attendance.
General information
5. Fire-fighting measures
Powder. Alcohol resistant foam. Dry chemicals. Carbon dioxide (CO2).
Suitable extinguishing media
Do not use water jet as an extinguisher, as this will spread the fire.
Unsuitable extinguishing
media
Contents under pressure. Pressurized container may explode when exposed to heat or flame.
During fire, gases hazardous to health may be formed.
Specific hazards arising from
the chemical
Firefighters must use standard protective equipment including flame retardant coat, helmet with
face shield, gloves, rubber boots, and in enclosed spaces, SCBA.
Special protective equipment
and precautions for firefighters
Move containers from fire area if you can do so without risk. Cool containers exposed to heat with
water spray and remove container, if no risk is involved. Containers should be cooled with water to
prevent vapor pressure build up. For massive fire in cargo area, use unmanned hose holder or
monitor nozzles, if possible. If not, withdraw and let fire burn out.
Fire fighting
equipment/instructions
Use standard firefighting procedures and consider the hazards of other involved materials. Move
containers from fire area if you can do so without risk. In the event of fire and/or explosion do not
breathe fumes.
Specific methods
Combustible. Flammable aerosol.
General fire hazards
6. Accidental release measures
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Wear
appropriate protective equipment and clothing during clean-up. Do not breathe gas. Do not touch
damaged containers or spilled material unless wearing appropriate protective clothing. Ventilate
closed spaces before entering them. Local authorities should be advised if significant spillages
cannot be contained. For personal protection, see section 8 of the SDS.
Personal precautions,
protective equipment and
emergency procedures
Refer to attached safety data sheets and/or instructions for use. Keep combustibles (wood, paper,
oil, etc.) away from spilled material. Isolate area until gas has dispersed. The product is immiscible
with water and will spread on the water surface. This material is classified as a water pollutant
under the Clean Water Act and should be prevented from contaminating soil or from entering
sewage and drainage systems which lead to waterways. Stop leak if you can do so without risk.
Move the cylinder to a safe and open area if the leak is irreparable. Use water spray to reduce
vapors or divert vapor cloud drift. Cover with plastic sheet to prevent spreading. Absorb in
vermiculite, dry sand or earth and place into containers. Following product recovery, flush area
with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination. For waste disposal, see section 13 of the SDS.
Methods and materials for
containment and cleaning up
Avoid release to the environment. Prevent further leakage or spillage if safe to do so. Avoid
discharge into drains, water courses or onto the ground. Inform appropriate managerial or
supervisory personnel of all environmental releases.
Environmental precautions
7. Handling and storage
Obtain special instructions before use. Do not handle until all safety precautions have been read
and understood. Pressurized container: Do not pierce or burn, even after use. Do not use if spray
button is missing or defective. Do not spray on a naked flame or any other incandescent material.
Do not smoke while using or until sprayed surface is thoroughly dry. Do not cut, weld, solder, drill,
grind, or expose containers to heat, flame, sparks, or other sources of ignition. All equipment used
when handling the product must be grounded. Do not re-use empty containers. Do not breathe
gas. Avoid contact with eyes, skin, and clothing. Avoid prolonged or repeated contact with skin.
Avoid prolonged exposure. Do not taste or swallow. When using, do not eat, drink or smoke.
Pregnant or breastfeeding women must not handle this product. Should be handled in closed
systems, if possible. Use only outdoors or in a well-ventilated area. Wear appropriate personal
protective equipment. Wash hands thoroughly after handling. Avoid release to the environment.
Observe good industrial hygiene practices.
Precautions for safe handling
3 / 15
Material name: Liquid Wrench White Lithium Grease
L616, L616/4 Version #: 03 Revision date: 02-15-2016 Issue date: 04-29-2015
SDS US