Installation Guide

ManualsBrandsLiquid Sunshine ManualsFencing5 ft. x 4 ft. Vinyl Outdoor Shower Stall Kit with Un-Assembled Gate

*Shower Curtain and Plumbing Sold Separately

Please Read Installation Instructions Completely Before Starting.

Summary of content (6 pages)

PAGE 1
Please Read Installation Instructions Completely Before Starting.
PAGE 2
Before You Begin: Check Local Zoning Laws. Zoning laws may restrict the location and height of your enclosure. Permits may also be required. Underground Utilities. Dial 811 to have underground utility lines marked. Even at shallow depths, utility lines can be present. Tools and Materials. Check that all tools and materials are present to properly assemble your enclosure.
PAGE 3
Parts List: ITEM # DESCRIPTION 1 2 3 4 5 6 7 8 9 10 4"x4" Post Pyramid Top 4"x4"x96" Vinyl Post White 41.75"x5.47"x42.125" Privacy Panel Rail 1.02"x1.379"x47.5" U-Channel 0.875"x6"x52" - 0.35W Tongue & Groove Board 0.875"x1.5"x44.125" Curtain Rod 1.75"x5.5" Bracket Kit (Screws Included) 0.875"x1.5" End Cap Pan Head Screw Screw Head Cap QTY.
PAGE 4
1. Dig a 3 foot deep by 10 inch diameter hole for each post footing. Use a post hole digger or an auger. 2. Slide 4x4 vinyl posts over 4x4x96" lumber so that 2 feet of lumber is extended below vinyl posts. Secure lumber to posts with included pan head screws below finish grade. 3. Insert posts and double-check measurements. Pour pre-mixed concrete into holes and use a post level to make plumb.
PAGE 5
Step-1 Bottom Rail 1. Slide brackets onto bottom rail and lift into place between posts. 2. Offset bottom brackets 10" above finish grade and center bottom rail on posts. 3. Mount brackets to posts using included 4 screws per bracket. Insert white screw head caps to hide screws. Step-2 Vertical Tongue and Groove Boards Step-3 Top Rail 1. Insert vertical tongue and groove boards into bottom rail from left to right. 1. Slide brackets onto top rail and place on top of vertical tongue and groove boards.
PAGE 6
Curtain Rod Installation 1. Attach end caps to ends of curtain rods. Use glue to create a stronger bond. 2. Place curtain rods on interior side of posts as shown. Mount curtain rods to posts using included 2 pan head screws per rod. Insert white caps to hide screws. Post Tops Installation: 1. Place post tops on top of posts. Use glue or post top clips to create a stronger bond.