Manual

51
Appendix ii
CONVERSION TABLE
Convert from:
ENGLISH
X
(CONVERSION FACTOR)
=
METRIC
ft
3
/min
X
1.69902
=
m
3
/h
GPM
X
0.063085
=
liters/sec
lbm/h
X
0.45359
=
kg/h
Btu/h
X
0.01757
=
kW
Btu/h
X
15.12
=
kcal/h
Btu/h
X
0.0633034
=
MJ/h
ft
3
X
0.028317
=
m
3
gals
X
3.785109
=
liters
lbm
X
0.45359
=
kg
Btu
X
0.0002928
=
kWh
Btu
X
0.252
=
kcal
Btu
X
0.001055056
=
MJ
Deg F
X
(0.555555) + (-17.7776)
=
Deg C
PSIG
X
6.894757
=
kPa
PSIG
X
0.070306
=
kg/cm
2
PSIG
X
0.06894757
=
bar
GPM
X
0.01337
=
ACFM
ACFM
X
7.4805
=
GPM
Appendix iii
PROGRAMMING ERROR MESSAGES
These messages occur when attempting to go to the running mode or entering a value that is not allowed.
NOTE: All Error messages are followed by the phrase: “Push ENT to continue” Pressing ENT does not correct the error nor
access the point of error. The menu must be accessed and correct data entered.
MESSAGES
TEMP HI-LO LIM ERR: Temperature input parameters have not been entered or a low limit is higher than a high limit.
PRESS HI-LO LIM ERR: Pressure input parameters have not been entered or a low limit is higher than a high limit.
FLOW HI-LO LIM ERR: Flow input parameters have not been entered or a low limit is higher than a high limit.
NEED MORE FLOW INFO:All of the flow input parameters have not been entered.
Z FACTOR ERROR: Z factor has been set to zero; change to any number greater than zero.
SCALE FACTOR ERROR: K factor has been set to zero; change to any number greater than zero.
NO VALUE STORED YET:The unit has a null value in it from initialization. Enter a value.
BAD LOCK CODE: Attempt has been made to enter 00000 as the lockout code; use any number other than 00000 to
lock out computer. In the lock confirming step, the 5 digit code entered is not the same as the 5
digits initially entered.
SYNTAX ERROR: Time or date was not entered in proper format. Refer to section 7.
BAD TIME VALUE: Invalid time entered. Refer to section 7.
BAD DATE VALUE: Invalid date entered. Refer to section 7.
BAD ID VALUE: RS-232 option only. Invalid unit ID entered. Refer to RS-232 instructions.